Description
Emulates behavior of Haltech IO 12 box.
- 4x 0v – 5v Analog inputs (built in switchable pullup resistors)
- 4x Digital Inputs (on – off state only)
- 4x Digital pulsed outputs (low side switched)
- Change from IO Box A or B by soldering across the solder bridge marked “AB”. (by default IO is in A mode)
Compatible with the following ECUs
- Haltech – PS, Elite and Nexus
- Link G4+, G4X, G5
- MAXXECU
- ECU Master Pro, ADU and PMU
Pullup resistors can be added for the Analog inputs by soldering across the relevant pads on the bottom of the board.
Note:
– 3A limit per channel, with a 7A overall limit for the outputs.
– No frequency drive for the outputs. State or PWM only. (490hz or 980hz)
– 0v-5v on the AVI.
– Input protection for AVI, 12v tolerant. Still reads 0-5v
-DPIs are state only (on or off), No Frequency measurements. Pull to ground. Also 12V tolerant.
-Built in pullup resistors are 1k ohm. Solder across the pads under rear cover to use them.
-Swap from A mode to B mode by bridging the “AB” solder pads under the rear cover.
Includes:
- PT Motorsport IO – DTM
- 1x DTM12 half kit
- 1x DTM6 half kit
- 1x DTM4 half kit
- 22x terminals
- Mounting hardware
